Click here

REAR COMBINATION LIGHT ASSEMBLY ON-VEHICLE INSPECTION

Click here
Click here
  1. Click here

    INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. A003Y6NE03

      Disconnect the connector from the rear combination light assembly LH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      P22-3 (TL) - P22-6 (E) Light control switch off Below 1 V
      Power switch off and light control switch in tail position 11 to 14 V
      P22-2 (STP) - P22-6 (E) Brake pedal released Below 1 V
      Power switch off and brake pedal depressed 11 to 14 V
      P22-4 (TRN)- P22-6 (E) Turn signal switch in neutral position Below 1 V
      Power switch on (IG) and turn signal switch in left turn position 11 to 14 V (60 to 120 times per minute)
      Table 1. Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly LH)

      If the result is not as specified, repair or replace the wire harness or connector.

  2. Click here

    INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    1. A003Y6NE05

      Disconnect the connector from the rear combination light assembly RH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      Q15-3 (TL) - Q15-6 (E) Light control switch off Below 1 V
      Power switch off and light control switch in tail position 11 to 14 V
      Q15-2 (STP) - Q15-6 (E) Brake pedal released Below 1 V
      Power switch off and brake pedal depressed 11 to 14 V
      Q15-4 (TRN) - Q15-6 (E) Turn signal switch in neutral position Below 1 V
      Power switch on (IG) and turn signal switch in right turn position 11 to 14 V (60 to 120 times per minute)
      Table 2. Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Combination Light Assembly RH)

      If the result is not as specified, repair or replace the wire harness or connector.