HEADLIGHT ASSEMBLY (for LED Headlight) REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. Remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  5. REMOVE DECK FLOOR BOX RH


    1. A003Z5J

      Remove the clip.

    2. Disengage the 6 guides and remove the deck floor box RH.

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    1. A003VKN

      Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.

  7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  9. REMOVE FRONT FENDER SIDE PANEL PROTECTOR


    1. A003WQY

      Disengage the 3 clips and 2 guides, and remove the front fender side panel protector.

  10. REMOVE HEADLIGHT ASSEMBLY


    1. A003WJD

      Remove the bolt and 2 screws.

    2. Disengage the claw.

    3. A003ZTM

      Disengage the clamp.

    4. Disconnect each connector and remove the headlight assembly.