REAR LIGHT ASSEMBLY REMOVAL


  1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A003X12

      Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.

  2. REMOVE BACK DOOR SIDE GARNISH LH


    1. A003XEI

      Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish LH.

  3. REMOVE BACK DOOR SIDE GARNISH RH


    1. A003VMK

      Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish RH.

  4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A003ZUJ

      Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.

    2. A003XVH

      Disengage the 13 clips and remove the back door trim board assembly.

  5. REMOVE REAR LIGHT ASSEMBLY


    1. A003ZTZ

      Disengage the clamp and disconnect the connector.

    2. Remove the 3 nuts and rear light assembly.