REAR LIGHT ASSEMBLY ON-VEHICLE INSPECTION


  1. REMOVE REAR LIGHT ASSEMBLY LH


    1. A003YJQE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Light Assembly LH)

      Disconnect the connector from the rear light assembly LH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      V9-2 (B/U)- V9-3 (E)*1 Power switch on (READY) and reverse (R) not selected Below 1 V
      Power switch on (READY) and reverse (R) selected 11 to 14 V
      V9-4 (B) - V9-3 (E)*2 Power switch on (READY), light control switch in tail position and rear fog light switch off Below 1 V
      Power switch on (READY), light control switch in tail position and rear fog light switch on 11 to 14 V

      • *1: w/o Rear fog light

      • *2: w/ Rear fog light

      If the result is not as specified, repair or replace the wire harness or connector.

  2. REMOVE REAR LIGHT ASSEMBLY RH


    1. A003YJQE04
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Rear Light Assembly RH)

      Disconnect the connector from the rear light assembly RH.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      V2-2 (B/U)- V2-3 (E)*1 Power switch on (READY) and reverse (R) not selected Below 1 V
      Power switch on (READY) and reverse (R) selected 11 to 14 V
      V2-4 (B)- V2-3 (E)*2 Power switch on (READY), light control switch in tail position and rear fog light switch off Below 1 V
      Power switch on (READY), light control switch in tail position and rear fog light switch on 11 to 14 V

      • *1: w/o Rear fog light

      • *2: w/ Rear fog light

      If the result is not as specified, repair or replace the wire harness or connector.