IGNITION COIL AND SPARK PLUG REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  2. REMOVE IGNITION COIL ASSEMBLY


    1. A003VYT

      Disconnect the 4 ignition coil connectors.

    2. Remove the 4 bolts and 4 ignition coils.

      Note

      When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.

  3. REMOVE SPARK PLUG


    1. A003ZL2

      Using a 14 mm spark plug wrench, remove the 4 spark plugs.