CAMSHAFT POSITION SENSOR REMOVAL

Tech Tips

Although the part name refers to the No. 1 crank position sensor, this procedure is for the camshaft position sensor.


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  2. REMOVE NO. 1 CRANK POSITION SENSOR


    1. A003WTIE01

      Disconnect the No. 1 crank position sensor connector.

    2. Remove the bolt and No. 1 crank position sensor.