ECM REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. Remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  5. REMOVE DECK FLOOR BOX RH


    1. A003Z5J

      Remove the clip.

    2. Disengage the 6 guides and remove the deck floor box RH.

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    1. A003VKN

      Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE INVERTER WITH CONVERTER ASSEMBLY

    Click here

  9. SEPARATE INVERTER RESERVE TANK ASSEMBLY


    1. A003W7F

      Remove the 2 bolts and separate the inverter reserve tank assembly.

  10. REMOVE ECM


    1. A003ZPF

      Separate the wire harness clamp.

    2. Disconnect the 2 ECM connectors.


      1. A003YXW

        Disconnect the wire harness clamp.

      2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. A003WNW

      Remove the 2 bolts and ECM.

    4. Remove the 4 screws and 2 ECM brackets.