AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL


    1. A003VJD

      Disengage the 2 claws and remove the No. 1 heater air duct splash shield seal.

  3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL


    1. A003Y4M

      Disengage the claw and guide, and remove the No. 2 heater air duct splash shield seal.

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH


    1. A003WMR

      Remove the 2 bolts and cowl body mounting reinforcement LH.

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    1. A003W0I

      Disengage the clamp and separate the wire harness.

    2. A003WSZ

      w/ Wiper Deicer:

      Disengage the 3 clamps, disconnect the connector and separate the wire harness.

    3. A003YRF

      Remove the 9 bolts and outer cowl top panel sub-assembly.

  6. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  7. REMOVE AIR FUEL RATIO SENSOR


    1. A003ZOQ

      Disconnect the air fuel ratio sensor connector and clamp.

    2. A003VHUE03

      Using SST, remove the air fuel ratio sensor.

      SST
      09224-00010