TEMPERATURE SWITCH REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  2. DRAIN COOLANT (for Engine)

    Note

    Do not remove the reserve tank cap and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. A003Z8O

      Loosen the radiator drain cock plug.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the local regulations.

    2. Remove the reserve tank cap and drain the coolant.

      A003ZHYE01
      Text in Illustration
      *1 Reserve Tank Cap *2 Radiator Drain Cock Plug

  3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A003YXL

      Disconnect the connector.

    2. A003XU2

      Using a union nut wrench (19 mm), remove the engine coolant temperature sensor.

      Note

      Do not apply any excessive force to the heater pipe when removing the engine coolant temperature sensor.