VACUUM SENSOR REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A003ZFN

      Disconnect the mass air flow meter connector.

    2. A003ZJP

      Separate the water hose from the hose clamp.

    3. Release the 2 clamps.

    4. Loosen the hose clamp and remove the air cleaner cap.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A003VRO

      Separate the water hose from the hose clamp.

    2. A003VGC

      Separate the wire harness clamp from the inlet air cleaner assembly.

    3. Remove the 2 bolts, 2 clips and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CASE


    1. Remove the air cleaner filter element sub-assembly.

    2. A003VMR

      Separate the hose from the hose clamp.

    3. Remove the 2 bolts and air cleaner case.

  5. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    1. A003YQK

      Disconnect the connector.

    2. Remove the bolt and manifold absolute pressure sensor.