PCV VALVE REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003WMME01

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Disengage the clips in the order shown in the illustration.

      • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A003ZFN

      Disconnect the connector and wire harness clamp.

    2. A003XA5

      Disconnect the water hose from the clamp.

    3. Disengage the 2 clamps and remove the air cleaner cap sub-assembly.

    4. Loosen the hose clamp and disconnect the air cleaner hose assembly.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A003VRO

      Separate the water hose from the hose clamp.

    2. A003VGC

      Separate the wire harness clamp from the inlet air cleaner assembly.

    3. Remove the 2 bolts, 2 clips and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CASE


    1. Remove the air cleaner filter element sub-assembly from the air cleaner case.

    2. A003VMR

      Disconnect the water hose from the clamp.

    3. Remove the 2 bolts and air cleaner case.

  5. REMOVE NO. 1 ENGINE UNDER COVER

  6. REMOVE VENTILATION VALVE SUB-ASSEMBLY


    1. A003W4F

      Remove the ventilation hose from the ventilation valve sub-assembly.

    2. A003YB2E01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench (22 mm)

      Using a ball joint lock nut wrench (22 mm), remove the ventilation valve sub-assembly.