PURGE VALVE REMOVAL

REMOVE NO. 2 CYLINDER HEAD COVER

1. 

   Remove the 3 clips and No. 2 cylinder head cover.

   Note:
   

   • Disengage the clips in the order shown in the illustration.

   • When disengaging clip 3, hold the end of the cover behind clip 3 and lift the cover straight up.

   • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

   • Pull the cover straight up to remove. Attempting to pull the cover forward or pull it up by holding the left and right ends may cause the cover to break.

REMOVE AIR CLEANER CAP SUB-ASSEMBLY

1. 

   Disconnect the connector and wire harness clamp.

2. 

   Disconnect the water hose from the clamp.

3. Disengage the 2 clamps and remove the air cleaner cap sub-assembly.

4. Loosen the hose clamp and disconnect the air cleaner hose assembly.

REMOVE INLET AIR CLEANER ASSEMBLY

1. 

   Separate the water hose from the hose clamp.

2. 

   Separate the wire harness clamp from the inlet air cleaner assembly.

3. Remove the 2 bolts, 2 clips and inlet air cleaner assembly.

REMOVE AIR CLEANER CASE

1. Remove the air cleaner filter element sub-assembly from the air cleaner case.

2. 

   Disconnect the water hose from the clamp.

3. Remove the 2 bolts and air cleaner case.