AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK

    Click here

  2. REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)


    1. A003TIT

      Remove the 3 bolts and cowl body mounting reinforcement LH.

  3. REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for RHD)


    1. A003UFL

      Remove the 3 bolts and cowl body mounting reinforcement LH.

  4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    1. A003S9NE01
      Text in Illustration
      *1 No. 1 Heater Air Duct Splash Shield Seal
      *2 Water Guard Plate RH

      Disengage each claw of the No. 1 heater air duct splash shield seal and water guard plate RH, and bend them.

    2. A003SJJ

      Disengage the clamp and separate the wire harness.

    3. Remove the 8 bolts, nut and outer cowl top panel.

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    1. A003RYXE01
      Text in Illustration
      *1 Water Guard Plate RH
      *2 No. 1 Heater Air Duct Splash Shield Seal

      Disengage each claw of the water guard plate RH and No. 1 heater air duct splash shield seal, and bend them.

    2. A003UWL

      Disengage the clamp and separate the wire harness.

    3. Remove the 8 bolts, nut and outer cowl top panel.

  6. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A003S7G

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

  7. REMOVE AIR FUEL RATIO SENSOR


    1. A003U20

      Disconnect the air fuel ratio sensor connector and clamp.

    2. A003URHE02

      Using SST, remove the air fuel ratio sensor.

      SST
      09224-00010