REAR CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY


    1. Remove the hybrid vehicle transaxle assembly Click here.

      Note

      Be careful not to apply excess force to the transmission input damper assembly when removing or installing the hybrid vehicle transaxle assembly. If excess force is applied, the transmission input damper assembly may be damaged, or its splines may become misaligned.

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A003RJ4E01

      Using SST, hold the crankshaft damper.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    2. A003UF0

      Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A003RJ4E01

      Using SST, hold the crankshaft damper.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    2. A003RSD

      Remove the 8 bolts and the flywheel.

  4. REMOVE REAR ENGINE OIL SEAL


    1. A003TKDE03
      Text in Illustration
      *1 Protective Tape
      *a Cut Position

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

      Note

      After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.