REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

    Necessary Procedures Effect / Inoperative Function When Necessary Procedures are not Performed See Page
    Reset back door close position Back door opener

    Click here

    Note

    When the auxiliary battery is replaced or the cable is disconnected from its negative (-) battery terminal, the ISC learning value will be initialized and symptoms as a loud rattle from the hybrid vehicle transaxle assembly may occur until ISC learning is performed. Therefore, perform ISC learning when the auxiliary battery is replaced or the cable is disconnected from the negative (-) terminal of the auxiliary battery Click here.

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Replacement Part Necessary Procedure Effect / Inoperative Function when Necessary Procedures are not Performed See Page
    Brake booster with master cylinder (Skid control ECU, brake actuator or pressure sensor)

    1. Initialization and calibration of the linear solenoid valve

    2. Yaw rate and acceleration sensor zero point calibration

    • ABS warning light illumination

    • Slip indicator light illumination

    • Brake warning light / yellow (minor malfunction) illumination

    • VSC disabled or malfunctioning

    Click here for initialization

    Click here for calibration

    • Brake pedal stroke sensor

    • Brake pedal

    1. Clearing stored linear solenoid valve calibration data

    2. Initialization and calibration of the linear solenoid valve

    • ABS warning light illumination

    • Slip indicator light illumination

    • Brake warning light / yellow (minor malfunction) illumination

    • VSC disabled or malfunctioning
    Yaw rate and acceleration sensor

    1. Clearing zero point calibration data

    2. Yaw rate and acceleration sensor zero point calibration

    • ABS warning light illumination

    • Slip indicator light illumination

    • Brake warning light / yellow (minor malfunction) illumination

    • VSC disabled or malfunctioning
    Power steering ECU Rotation angle sensor initialization and torque sensor zero point calibration

    • P/S warning light comes on

    • EPS control

    Click here

    Steering column assembly Rotation angle sensor initialization and torque sensor zero point calibration Steering effort is different between turning steering wheel to left and right

    • Certification ECU (smart key ECU assembly)

    • ID code box (immobiliser code ECU)

    • Transmission control ECU assembly

    • Electrical Key

    		 Code registration (Engine immobiliser system)

    • Wireless door lock control system

    • Entry and start system

    • Hybrid control system start

    		 See the Service Bulletin for the registration method.

    • Power window regulator motor

    • Door window regulator

    		 Initialize power window control system

    • Automatic door glass open/ close function

    • Jam protection function

    • Operation function after power switch is turned off

    Click here


    • Sliding roof ECU (sliding roof drive gear)

    • Sliding roof housing

    • Sliding roof drive cable

    		 Perform sliding roof drive gear reset

    • Automatic open/close function of roof glass

    • Jam protection function

    • Operation function after power switch off

    Click here

    Rear height control sensor sub-assembly Perform headlight leveling ECU initialization Automatic leveling function

    Click here

    Headlight leveling ECU Perform headlight leveling ECU initialization

    • Automatic leveling function

    • Headlight beam level control system warning light blinks