STEERING GEAR INSPECTION


  1. INSPECT TIE ROD END SUB-ASSEMBLY LH


    1. A003UXF

      Secure the tie rod end sub-assembly LH in a vise.

      Note

      Do not overtighten the vise.

    2. Install the nut to the stud bolt.

    3. Flip the ball joint back and forth 5 times.

    4. Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

      Standard turning torque
      1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)

      Tech Tips

      If turning torque is not within the specified range, replace the tie rod end sub-assembly LH with a new one.

  2. INSPECT TIE ROD END SUB-ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  3. INSPECT TOTAL PRELOAD


    1. A003TJME01

      Using SST and a torque wrench, inspect the total preload.

      SST
      09616-00011
      Standard preload
      0.7 to 1.1 N*m (7 to 11 kgf*cm, 6 to 9 in.*lbf)

      Note

      Inspect around the steering rack center position.

      Tech Tips

      If the total preload is not within the specified range, replace the steering gear assembly with a new one.