FRONT BRAKE FLEXIBLE HOSE REMOVAL

Note

If both RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. DISABLE BRAKE CONTROL


    1. Wait at least 2 minutes after the power switch off.

      Note

      When the brake pedal is depressed or the door courtesy switch is turned on even if the power switch is off, the brake control system activates. Therefore do not depress the brake pedal or open/close the doors until the reservoir level switch connector is disconnected.

    2. A003S3N

      Disconnect the reservoir level switch connector with the parking brake applied.

    3. Disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.

    5. Check that the brake pedal can not be further depressed.

    6. Release the parking brake.

  5. REMOVE FRONT WHEEL

  6. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  7. REMOVE FRONT FLEXIBLE HOSE


    1. A003U2Y

      Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.

    2. A003UQZE01
      Text in Illustration
      *1 Clip

      Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

    3. Remove the clip.

    4. A003UOLE01
      Text in Illustration
      *1 Front Speed Sensor Bracket
      *2 Front Flexible Hose Bracket

      Remove the bolt (A) and separate the front speed sensor bracket from the absorber bracket.

    5. Remove the bolt (B) and front flexible hose from the steering knuckle.