FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front axle hub and bearing assembly.


  1. INSTALL FRONT SPEED SENSOR


    1. Install the front speed sensor to the steering knuckle with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 76 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

      • After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.

      • Before installing the clamp, firmly insert the points of the clamp into the installation holes.

    2. Temporarily install the front brake flexible hose.

      A003TL3E01
      Text in Illustration
      *1 Front Brake Flexible Hose *2 No. 1 Sensor Clamp

    3. Install the front brake flexible hose and No. 1 sensor clamp together to the front shock absorber assembly with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing the front speed sensor.

      • The bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front speed sensor is positioned over the front brake flexible hose.

    4. A003URG

      Install the clamp to the front shock absorber assembly.

    5. Install the No. 2 sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 76 in.*lbf }

    6. Connect the front speed sensor connector.

    7. Install the 2 clamps.

  2. INSTALL FRONT FENDER LINER

  3. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL BATTERY BOX COVER


    1. Engage the 3 guides to install the battery box cover.

  6. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  7. INSTALL REAR FLOOR MAT


    1. Install the rear floor mat.

  8. CHECK FOR SPEED SENSOR SIGNAL

    Click here