FRONT SPEED SENSOR REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front axle hub and bearing assembly.


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE FRONT WHEEL

  6. REMOVE FRONT FENDER LINER

  7. REMOVE FRONT SPEED SENSOR


    1. A003SRC

      Remove the 2 clamps.

    2. Disconnect the front speed sensor connector.

    3. A003UFXE01
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Remove the bolt and No. 2 sensor clamp.

    4. A003UYVE01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose

      Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the front shock absorber assembly.

    5. Remove the clamp from the front shock absorber assembly.

    6. A003UKM

      Remove the bolt and front speed sensor from the steering knuckle.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.