TIRE AND WHEEL SYSTEM INSPECTION


  1. INSPECT TIRES


    1. Check the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size

      Front

      kPa (kgf/cm2, psi)

      Rear

      kPa (kgf/cm2, psi)
      195/65R15 91H 250 (2.5, 36) 240 (2.4, 35)
      215/45R17 87W

      230 (2.3, 33)*1

      250 (2.5, 36)*2

      220 (2.2, 32)*1

      250 (2.5, 36)*2

      *1: For driving under 160 km/h (100 mph)

      *2: For driving at over 160 km/h (100 mph)

    2. A003TW9

      Using a dial indicator, check the runout of the tires.

      Maximum tire runout
      1.4 mm (0.0551 in.)

  2. ROTATE TIRES


    1. A003U9PE02
      Text in Illustration
      *1 Front

      Rotate the tires as shown in the illustration.

  3. INSPECT WHEEL BALANCE


    1. A003TD2E08

      Check and adjust the off-the-car balance.

      Maximum imbalance after adjustment
      8.0 g (0.0176 lb)

      Note


      • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

      • Do not touch the adhesive surface of the tape.

      • Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A)
        25 mm (0.984 in.)

      • Push the balance weight securely with your finger to adhere it to the position.

      • Do not reuse the balance weight.

      Tech Tips

      The inner side balance weight should be installed by clipping it to the rim.

  4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  5. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  6. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  7. INSPECT REAR AXLE HUB RUNOUT

    Click here