FRONT LOWER BALL JOINT REMOVAL

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT AXLE ASSEMBLY

    Click here

  2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY


    1. Secure the front axle assembly in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Remove the cotter pin and nut.

    3. A003SCQE07
      Text in Illustration
      *a 1mm

      Install SST to the front lower ball joint assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02050, 09961-02050 )

      Note

      Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.04 in.).

    4. A003USUE12
      Text in Illustration
      *a Apply grease.
      *b Place the wrench here.

      Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

      SST
      09960-20010   ( 09961-02010, 09961-02050, 09961-02050 )

      CAUTION:

      Apply grease to the threads and end of the SST bolt.

      Note


      • Install SST so that A and B are parallel.

      • Be sure to place the wrench on the part indicated in the illustration.

      • Do not damage the front lower ball joint dust cover.