STEERING KNUCKLE INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL STEERING KNUCKLE

    A003STZ

    1. Secure the steering knuckle between aluminium plates in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Install the front brake dust cover to the steering knuckle.

    3. Install the front axle hub sub-assembly with the 4 bolts.

      Torque:
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }

      Note

      Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

  2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY


    1. Secure the front axle assembly in a vise.

      Note

      When using a vise, do not overtighten it.

    2. A003SIZ

      Install the front lower ball joint assembly to the front axle assembly with the nut.

      Torque:
      133 N*m  { 1356 kgf*cm, 98 ft.*lbf }

    3. Install a new cotter pin.

      Note

      Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

  3. INSTALL FRONT AXLE ASSEMBLY

    Click here