HYBRID BATTERY SYSTEM, Diagnostic DTC:P0A95-123

DTC Code DTC Name
P0A95-123 High Voltage Fuse

DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
P0A95-123 Voltage between VC9 and VC10 terminals is below the standard despite the interlock switch being engaged (1 trip detection)

  • Service plug grip

  • HV battery

WIRING DIAGRAM

A003SCGE01

INSPECTION PROCEDURE

CAUTION:


  • Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.

  • After removing the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals. After waiting for 10 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work Click here.

Tech Tips

Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

PROCEDURE


  1. CHECK DTC OUTPUT (HV)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Check if DTCs are output.

      Result
      Result Proceed to
      P0AFC-123 is not output. A
      P0AFC-123 is also output. B

    5. Turn the power switch off.


    B

    GO TO DTC CHART Click here

    A

  2. CHECK SERVICE PLUG GRIP


    1. Turn the power switch off.

    2. Check that the service plug grip is not installed.

      Note

      After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

    3. A003S54E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Standard Resistance
      Service plug grip Below 1 Ω

    NG

    REPLACE SERVICE PLUG GRIP Click here

    OK

    REPLACE HV BATTERY Click here

  3. REPLACE SERVICE PLUG GRIP

    Click here


    NEXT

  4. RECONFIRM DTC OUTPUT (HV)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

    4. Read output DTCs Click here.

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are also output. B

    5. Disconnect the intelligent tester from the DLC3.


    B

    GO TO DTC CHART Click here

    A

    RECOVERY TO NORMAL