STEERING PAD SWITCH INSTALLATION

INSTALL STEERING PAD SWITCH RH
1. Engage the 2 pins and claw to install the steering pad switch RH.
2. Install the screw.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
3. Engage the clamp.
4. Connect the connector to the spiral cable.
INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 pins and claw to install the right side of the steering pad switch assembly.
2. Install the screw.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
3. Engage the 2 pins and claw to install the left side of the steering pad switch assembly.
4. Install the screw.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
5. Engage the 2 clamps.
6. Connect the connector to the spiral cable.
INSTALL STEERING PAD
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Connect the airbag connector to the steering pad.
  
  Note
  
  When connecting any airbag connector, take care not to damage the airbag wire harness.
4. Push in the lock to install the airbag connector.
5. Connect the horn connector to the steering pad as shown in the illustration.
6. Push the steering pad to engage the 2 hooks.
  
  Note
  
  Make sure that the hooks are securely inserted into the steering pad holes.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL BATTERY BOX COVER
1. Engage the 3 guides to install the battery box cover.
INSTALL REAR DECK FLOOR BOX
1. Install the rear deck floor box.
INSTALL REAR FLOOR MAT
1. Install the rear floor mat.
INSPECT STEERING PAD
1. Make sure that the horn sounds.
  
  Tech Tips
  
  If the horn does not sound, inspect the horn system Click here.
INSPECT SRS WARNING LIGHT

Click here