STEERING PAD SWITCH INSPECTION


  1. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Disconnect the steering pad switch assembly connector.

      A003S7NE01

    2. Measure the resistance according to the values in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      AU1 - EAU No switch pushed 95 to 105 kΩ
      AU1 - EAU Seek+ switch pushed Below 2.5 Ω
      AU1 - EAU Seek- switch pushed 313 to 345 Ω
      AU1 - EAU Volume+ switch pushed 950 to 1050 Ω
      AU1 - EAU Volume- switch pushed 2955 to 3265 Ω
      AU2 - EAU No switch pushed 95 to 105 kΩ
      AU2 - EAU MODE switch pushed Below 2.5 Ω
      AU2 - EAU*1 Voice switch pushed 2955 to 3265 Ω
      AU2 - EAU*1 On hook switch pushed 313 to 345 Ω
      AU2 - EAU*1 Off hook switch pushed 950 to 1050 Ω
      DISP - EAU No switch pushed 95 to 105 kΩ
      DISP - EAU DISP switch pushed Below 2.5 Ω

      • *1: w/ Microphone

      Text in Illustration
      *A w/ Microphone - -
      *a

      Component without harness connected

      (Steering Pad Switch Assembly)

      		 *b

      Component without harness connected

      (Steering Pad Switch RH)
      *c Seek+ *d Volume+
      *e Seek- *f MODE
      *g Volume- *h On hook
      *i DISP *j Voice
      *k Off hook - -

      If the result is not as specified, replace the steering pad switch assembly.