STEERING PAD SWITCH REMOVAL


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. PRECAUTION

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE STEERING PAD

    CAUTION:

    When storing the steering pad, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A003SHB

      Using a screwdriver, push the 2 torsional springs to disengage the 2 hooks.

      Note

      Do not drop the steering pad.

    4. A003S14E02
      Text in Illustration
      *1 Protective Tape

      Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    5. Disconnect the horn connector from the steering pad.

    6. Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.

    7. Disconnect the airbag connector to remove the steering pad.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  7. REMOVE STEERING PAD SWITCH RH


    1. A003SQ6

      Disconnect the pad switch connector from the spiral cable.

    2. Disengage the clamp.

    3. A003SSF

      Remove the screw.

    4. Disengage the 2 pins and claw, and remove the steering pad switch RH.

  8. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. A003UUO

      Disconnect the pad switch connector from the spiral cable.

    2. Disengage the 2 clamps.

    3. A003U7P

      Remove the screw.

    4. Disengage the 2 pins and claw, and remove the left side of the steering pad switch assembly.

    5. A003SQ8

      Remove the screw.

    6. Disengage the 2 pins and claw, and remove the right side of the steering pad switch assembly.