REAR DOOR SPEAKER REMOVAL


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL


    1. A003UPWE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A003TX0E02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003RKD

      Remove the 3 screws.

    2. A003UCF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 3 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

    4. A003SUF

      Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

    5. Disconnect the connector.

  4. REMOVE REAR SPEAKER ASSEMBLY


    1. A003UR5

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.