FRONT DOOR SPEAKER REMOVAL


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL


    1. A003RJAE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A003T8OE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003T3P

      Remove the 3 screws.

    2. A003SYF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 4 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

    4. A003SJL

      Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

    5. Disconnect each connector.

  4. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A003T25

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the front No. 1 speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

  5. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. A003UBT

      Disengage the 3 claws and remove the front No. 2 speaker assembly.