FRONT DOOR BELT MOULDING REMOVAL


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL


    1. A003RJAE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A003T8OE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003T3P

      Remove the 3 screws.

    2. A003SYF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 4 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

    4. A003SJL

      Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

    5. Disconnect each connector.

  4. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


    1. A003T68

      Disconnect the front door lock remote control cable and front door inside locking cable, and remove the front door inside handle sub-assembly.

  5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. A003U7T

      Remove the front door inner glass weatherstrip from the front door panel.

  6. REMOVE FRONT DOOR SERVICE HOLE COVER


    1. A003S7R

      Disconnect the connector.

    2. Remove the front door service hole cover.

      Tech Tips

      Remove the remaining butyl tape on the door.

  7. REMOVE OUTER MIRROR INSTALL HOLE COVER


    1. A003UJL

      Disengage the 3 claws and the guide, and remove the outer mirror install hole cover.

  8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER


    1. A003SBH

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Disengage the claw and remove the outer rear view mirror assembly with cover.

  9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY


    1. Connect the negative battery terminal.

    2. Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

    3. Disconnect the negative battery terminal and power window regulator master switch assembly.

    4. A003TNQ

      Remove the 2 bolts.

      Note

      After the bolts are removed, the door glass may fall, causing damage.

    5. A003UMBE01

      Remove the front door glass sub-assembly as shown in the illustration.

      Note

      Do not damage the door glass.

  10. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. A003S5SE02
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door belt moulding assembly.

    2. Using a screwdriver with the tip taped, disengage the 5 claws from the inside of the door.

    3. Using a moulding remover, disengage the clip and remove the front door belt moulding assembly.