TURN SIGNAL FLASHER ASSEMBLY INSPECTION


  1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    1. A003SQ5E55
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Turn Signal Flasher Assembly)

      Disconnect the E71 turn signal flasher assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E71-1 (IG) - Body ground Power switch on (IG) 11 to 14 V
      E71-4 (B) - Body ground Always 11 to 14 V

      If the result is not as specified, there is a malfunction on the wire harness side.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E71-5 (EL) - Body ground Turn signal switch OFF 10 kΩ or higher
      Turn signal switch in LH position Below 1 Ω
      E71-6 (ER) - Body ground Turn signal switch OFF 10 kΩ or higher
      Turn signal switch in RH position Below 1 Ω
      E71-7 (E) - Body ground Always Below 1 Ω
      E71-8 (HAZ) - Body ground Hazard warning switch OFF 10 kΩ or higher
      Hazard warning switch ON Below 1 Ω

      If the result is not as specified, there is a malfunction on the wire harness side.

    4. A003SASE17
      Text in Illustration
      *1

      Component without harness connected

      (Turn Signal Flasher Assembly)

      Reconnect the E71 turn signal flasher assembly connector.

    5. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E71-2 (LR) - Body ground Hazard warning switch OFF Below 1 V
      Hazard warning switch ON 11 to 14 V (60 to 120 times per minute)
      Turn signal switch OFF Below 1 V
      Power switch on (IG) and turn signal switch in RH position 11 to 14 V (60 to 120 times per minute)
      E71-3 (LL) - Body ground Hazard warning switch OFF Below 1 V
      Hazard warning switch ON 11 to 14 V (60 to 120 times per minute)
      Turn signal switch OFF Below 1 V
      Power switch on (IG) and turn signal switch in LH position 11 to 14 V (60 to 120 times per minute)

      If the result is not as specified, replace the turn signal flasher assembly.