RAIN SENSOR INSTALLATION

INSTALL RAIN SENSOR TAPE

1. 

   Text in Illustration

   *1	Rain Sensor Tape

   Remove the releasing sheet (yellow side) from a new rain sensor tape and attach the tape to the position indicated in the illustration (the sensor part of the rain sensor) while pushing out air bubbles with your fingers.

   Standard Clearance

   Area	Measurement
   A	7.3 mm (0.287 in.)
   B	13.5 mm (0.532 in.)

2. Remove the releasing sheet (white side) from the rain sensor tape.

   Note

   
   

   • The rain sensor tape can be reused. However, replace it with a new one if it is dirty or damaged.

   • Check that the old rain sensor tape is not left on the windshield glass. If the tape is still on the windshield glass, remove it before installing the rain sensor.

   • Do not touch the sensor tape surface or the glass surface directly with your fingers.

   • Clean up dirt on the glass with a piece of cloth, etc.

INSTALL RAIN SENSOR

1. Connect the connector.

2. 

   Text in Illustration

   *1

   Stopper

   Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

3. Push in the stopper.

   Note

   
   

   • Do not touch the sensor tape surface or the glass surface directly with your fingers.

   • Clean up dirt on the glass with a piece of cloth, etc.

   • After installing the rain sensor, there should be no air bubbles between the windshield glass and the rain sensor tape.

INSTALL RAIN SENSOR COVER