WASHER NOZZLE ON-VEHICLE INSPECTION


  1. INSPECT FRONT WASHER NOZZLE SUB-ASSEMBLY


    1. With the engine running, check the position that the washer fluid hits the windshield.

      A003SSAE02
      Standard Clearance
      Area Measurement Area Measurement
      A 345 mm (13.583 in.) B 77 mm (3.0315 in.)
      C 575 mm (22.638 in.) D 53 mm (2.0866 in.)
      Text in Illustration
      *1 Upper Limit *2 Standard
      *3 Lower Limit - -
      OK
      Washer fluid hits the windshield in the areas shown in the illustration.

      Tech Tips

      If the result is not as specified, replace the washer nozzle sub-assembly.

  2. INSPECT REAR WASHER NOZZLE SUB-ASSEMBLY


    1. With the engine running, check the position that washer fluid hits the back door glass.

      A003RV5E03
      Standard Clearance
      Area Measurement
      A 3.5 mm (0.14 in.)
      B 65 mm (2.56 in.)
      OK
      Washer fluid hits the back door glass in the area shown in the illustration.

      Tech Tips

      If the result is not as specified, replace the washer nozzle sub-assembly.