OUTER REAR VIEW MIRROR REMOVAL


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL


    1. A003RJAE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel.

  2. REMOVE DOOR ASSIST GRIP COVER


    1. A003T8OE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003T3P

      Remove the 3 screws.

    2. A003SYF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 4 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

    4. A003SJL

      Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

    5. Disconnect each connector.

  4. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


    1. A003T68

      Disconnect the front door lock remote control cable and front door inside locking cable, and remove the front door inside handle sub-assembly.

  5. REMOVE FRONT DOOR SERVICE HOLE COVER


    1. A003S7R

      Disconnect the connector.

    2. Remove the front door service hole cover.

      Tech Tips

      Remove the remaining butyl tape on the door.

  6. REMOVE OUTER MIRROR INSTALL HOLE COVER


    1. A003UJL

      Disengage the 3 claws and the guide, and remove the outer mirror install hole cover.

  7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER


    1. A003SBH

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Disengage the claw and remove the outer rear view mirror assembly with cover.

  8. REMOVE OUTER MIRROR GLASS


    1. Apply protective tape to the bottom of the visor of the door mirror.

    2. Push the upper part of the mirror surface and tilt it.

    3. A003T0ME01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover

      Using a moulding remover, disengage the 8 claws.

    4. Remove the outer mirror glass.

    5. w/ Heater:


      1. A003UT4

        Disconnect the connectors and remove the outer mirror glass.

  9. REMOVE OUTER MIRROR COVER


    1. A003U4B

      Disengage the 6 claws and remove the outer mirror cover from the outer rear view mirror assembly with cover.

  10. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    1. A003UN7

      Disconnect the connector.

    2. Remove the 3 screws and the side turn signal light assembly.