SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A003RKYE01
      Text in Illustration
      *a

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))
      *1 Sliding Roof Switch

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      8 (UP) - 7 (GND) TILT UP switch is pressed Below 1 Ω
      8 (UP) - 7 (GND) TILT UP switch is not pressed 10 kΩ or higher
      9 (DOWN) - 7 (GND) SLIDE OPEN switch is pressed Below 1 Ω
      9 (DOWN) - 7 (GND) SLIDE OPEN switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).