SLIDING ROOF HOUSING REASSEMBLY


  1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A003SMK

      Insert the sliding roof drive cable.

    2. Align the sliding roof drive cable with the guide on the sliding roof housing and slide the cable in the direction indicated by the arrow in the illustration.

    3. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

      A003UBZE05
      Text in Illustration
      *1 Window Deflector *2 Sliding Roof Drive Cable Sub-assembly
      *3 Hold the window deflector down until the sliding roof drive cable sub-assembly runs on the window deflector. - -

      Note

      Make sure that the spring indicated by the arrow in the illustration is securely installed.

    4. A003SXZ

      Engage the 2 claws and install the sliding roof drip channel.

    5. A003RK9

      Install the 2 sliding roof side stoppers with the 2 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

      Tech Tips

      Use the same procedure for the RH side and LH side.

  2. ADJUST FULLY CLOSED POSITION


    1. A003S05E03
      Text in Illustration
      *1 Matchmark

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction indicated by the arrows in the illustration and align the matchmarks.

      Tech Tips

      Tape the screwdriver tip before use.

  3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A003SSB

      Insert the sunshade trim into the sliding roof housing sub-assembly.

    2. A003T98

      Align the sliding roof piece sub-assembly LH with the guide on the sliding roof housing to temporarily install it.

    3. A003UCP

      Install the sliding roof piece sub-assembly LH with the screw.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

      Tech Tips

      Use the same procedure for the RH side and LH side.

  4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A003SZG

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }