POWER WINDOW REGULATOR MOTOR (for Rear Door) REMOVAL


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR DOOR INSIDE HANDLE BEZEL


    1. A003UPWE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel.

  6. REMOVE DOOR ASSIST GRIP COVER


    1. A003TX0E02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003RKD

      Remove the 3 screws.

    2. A003UCF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 3 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

    4. A003SUF

      Disengage the 2 claws and disconnect the rear door inside handle sub-assembly.

    5. Disconnect the connector.

  8. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


    1. A003T68

      Disconnect the rear door lock remote control cable and rear door inside locking cable, and remove the rear door inside handle sub-assembly.

  9. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP


    1. A003SL7

      Remove the rear door inner glass weatherstrip from the rear door panel.

  10. REMOVE REAR DOOR SERVICE HOLE COVER


    1. A003TZR

      Disconnect the connector.

    2. Remove the rear door service hole cover.

      Tech Tips

      Remove the remaining tape on the door.

  11. REMOVE REAR DOOR WEATHERSTRIP


    1. A003TZY

      Remove the upper part of the rear door weatherstrip to the extent that allows.

  12. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY


    1. A003TOO

      Remove the 2 bolts, screw, and rear door window division bar sub-assembly.

  13. REMOVE REAR DOOR QUARTER WINDOW GLASS


    1. A003S1N

      Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.

    2. Remove the rear door quarter window glass from the rear door quarter window weatherstrip.

  14. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


    1. A003USN

      Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.

      Note

      Do not damage the door glass.

  15. REMOVE REAR DOOR GLASS RUN


    1. A003TZP

      Remove the rear door glass run.

  16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY


    1. A003SAIE02
      Text in Illustration
      *1 Temporary Bolt

      Disconnect the connector.

    2. Loosen the temporary bolt.

      Note

      Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall, causing damage.

    3. Remove the 3 bolts and the rear door window regulator assembly.

    4. Remove the temporary bolt from the rear door window regulator assembly.