POWER WINDOW REGULATOR MOTOR (for Front Door) REMOVAL


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL


    1. A003RJAE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel.

  6. REMOVE DOOR ASSIST GRIP COVER


    1. A003T8OE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A003T3P

      Remove the 3 screws.

    2. A003SYF

      Using a clip remover, disengage the 9 clips.

    3. Disengage the 4 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

    4. A003SJL

      Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

    5. Disconnect each connector.

  8. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


    1. A003T68

      Disconnect the front door lock remote control cable and front door inside locking cable, and remove the front door inside handle sub-assembly.

  9. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. A003U7T

      Remove the front door inner glass weatherstrip from the front door panel.

  10. REMOVE FRONT DOOR SERVICE HOLE COVER


    1. A003S7R

      Disconnect the connector.

    2. Remove the front door service hole cover.

      Tech Tips

      Remove the remaining butyl tape on the door.

  11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY


    1. Connect the negative battery terminal.

    2. Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

    3. Disconnect the negative battery terminal and power window regulator master switch assembly.

    4. A003TNQ

      Remove the 2 bolts.

      Note

      After the bolts are removed, the door glass may fall, causing damage.

    5. A003UMBE01

      Remove the front door glass sub-assembly as shown in the illustration.

      Note

      Do not damage the door glass.

  12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY


    1. A003SHGE02
      Text in Illustration
      *1 Temporary Bolt

      Disconnect the connector.

    2. Loosen the temporary bolt.

      Note

      Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall, causing damage.

    3. Remove the 5 bolts.

    4. Remove the front door window regulator assembly and the front power window regulator motor assembly as a unit.

    5. Remove the temporary bolt from the front door window regulator assembly.