CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Install a new curtain shield airbag assembly with the 5 bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

      Note


      • If the curtain shield airbag assembly is removed, replace it with a new one.

      • Do not twist the curtain shield airbag assembly when installing it.

    4. Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.


      1. A003RI3E04
        Text in Illustration
        *1 Pin
        *2 Clip
        *3 Airbag
        *4 Body
        *5 Spacer

        Install 4 new pins as shown in the illustration.

        Note

        Make sure that the pins of the clips are pushed in firmly.

    5. Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    6. Push in the lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here