KNEE AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the driver side knee airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Engage the 6 claws and 2 guides.

    5. Temporarily install the driver side knee airbag assembly with the 2 bolts (upper side).

    6. Temporarily install the driver side knee airbag assembly with the 2 bolts (lower side).

    7. Install the driver side knee airbag assembly with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A003S74E03

      Engage the guide.

    2. Engage the claw.

    3. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <C> or <D>.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL BATTERY BOX COVER


    1. Engage the 3 guides to install the battery box cover.

  5. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  6. INSTALL REAR FLOOR MAT


    1. Install the rear floor mat.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here