FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY


    1. Connect the connector to install the instrument panel wire assembly on the front passenger airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    1. A003SXT

      Engage the 5 hooks.

    2. A003SGX

      Engage the 5 hooks to install the front passenger airbag assembly on the instrument panel.

  3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY


    1. When using a new upper instrument panel sub-assembly:


      1. A003RQD

        Immediately before installing the upper instrument panel sub-assembly, twist and cut off the portions shown in the illustration (joints for moulding).

    2. When using a new upper instrument panel sub-assembly:


      1. A003TZOE02
        Text in Illustration
        *1 Protective Tape

        Apply protective tape to the areas shown in the illustration.

    3. Engage the 5 claws.

      Note


      • When installing the upper instrument panel sub-assembly, be careful not to damage it or the steering wheel assembly.

      • Do not allow the wire harness to get caught in the claws.

    4. Engage the 3 claws and the 4 clips.

    5. Install the 2 screws <C> or <D>.

    6. Install the 2 passenger airbag bolts <A> or <B>.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    7. Connect the connector and install the upper instrument panel sub-assembly.

      A003RTVE01

    8. Remove the protective tape.

  4. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Connect the connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  5. INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here