DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus:
for Combination Meter: Body / Combination Meter / Data List.
for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
for Engine: Powertrain / Engine / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| P-Seatbelt Buckle SW | Front passenger side seat belt buckle switch/OFF or ON | OFF: Front passenger side seat belt unfastened | - |
| ON: Front passenger side seat belt fastened | |||
| Vehicle Speed Meter | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 199 km/h (124 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| Coolant Temperature | Engine coolant temperature/0 to 127.5°C (32 to 261.5°F) | After warming up: 80 to 100°C (176 to 212°F) |
|
| Multi Display Select Switch | DISP switch in the multi-information switch (steering pad switch assembly)/OFF or ON | OFF: DISP switch in the multi-information switch (steering pad switch assembly) not pressed | - |
| ON: DISP switch in the multi-information switch (steering pad switch assembly) pressed | |||
| +B Voltage Value | Battery voltage/Min.: 0 V, Max.: 25.5 V | 11 to 14 V | - |
| Fuel Input | Fuel input signal/Min.: 0, Max. 127.5 | 9th bar comes on: 39.6 to 42.6 | Unit: Liters |
| 8th bar comes on: 34.5 to 39.6 | |||
| 7th bar comes on: 27.9 to 34.5 | |||
| 6th bar comes on: 24.9 to 27.9 | |||
| 5th bar comes on: 20.3 to 24.9 | |||
| 4th bar comes on: 15.6 to 20.3 | |||
| 3rd bar comes on: 10.8 to 15.6 | |||
| 2nd bar comes on: 6.75 to 10.8 | |||
| 1st bar blinks: 3.4 to 6.75 | |||
| Ambient Temperature | Outside temperature/-40 (-40°F) to 87.5°C (189.5°F) | Almost same as actual outside temperature | The temperature displayed on the multi-information display is -30 to 50°C (-22 to 122°F) |
| HV System Indicator | Hybrid system indicator value/Min.: -512, Max.: 511 (%) | -512: with park (P), reverse (R), neutral (N) selected | - |
| -100 to 511: Shift selection except above | - | ||
| Oil Pressure Switch | Oil pressure switch/OFF or ON | OFF: Engine oil pressure low | - |
| ON: Engine oil pressure not low | |||
| Driver Side Seatbelt Warning Buzzer | The condition of the driver side seat belt warning buzzer/OFF or ON | OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened | The customized setting of the driver side seat belt warning buzzer is displayed |
| ON: The driver side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened | |||
| P-Seatbelt Warning Buzzer | The condition of the front passenger side seat belt warning buzzer/OFF or ON | OFF: The front passenger side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened | The customized setting of the front passenger side seat belt warning buzzer is displayed |
| ON: The front passenger side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened | |||
| Reverse Buzzer | The customized setting of the reverse buzzer/Continual or Single | Continual: When the shift lever moves to R, buzzer sounds continuously | The customized setting of the reverse buzzer displayed |
| Single: When the shift lever moves to R, a single buzzer sounds | |||
| Number of Trouble Code | The number of the DTCs that are stored | 0 | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| FR Wheel Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| FL Wheel Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| RR Wheel Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| RL Wheel Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| Vehicle Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) | Almost the same as actual vehicle speed (Speedometer tester) | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Coolant Temp | Engine coolant temperature/Min.: -40°C (-40°F), Max: 215°C (419°F) | 80 to 100°C (176 to 212°F): After warming up |
|
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | 0, 40, 80, 120 mph*1 | - |
| 0, 40, 80, 120, 160, 200, 240 km/h*2 | |||
| Fuel Meter Operation | Fuel receiver gauge | Full, 1/2, Empty, Off | - |
| A/T Indicator Operation 1 | Shift indicator light (D, P, N, R, B) | D, P, N, R, B | - |
| Indicat. Lamp Airbag | SRS warning light | OFF or ON | - |
| Front Passenger Side Seat Belt | Front passenger side seat belt warning light | OFF or ON | - |
| Driver Side Seat Belt | Driver side seat belt warning light | OFF or ON | - |
| Indicat. Lamp ABS | ABS warning light | OFF or ON | - |
| Indicat. Lamp Charge | Charge warning light | OFF or ON | - |
| Indicat. Lamp Slip | Slip indicator light | OFF or ON | - |
| Indicat. Lamp Beam | High beam indicator light | OFF or ON | - |
| Indicat. Lamp Tail | Tail indicator light | OFF or ON | - |
| Indicat. Lamp Fr FOG | Front fog indicator light | OFF or ON | - |
| Indicat. Lamp Rr FOG | Rear fog indicator light | OFF or ON | - |
| Indicat. Lamp ECB | Electrically controlled brake warning light | OFF or ON | - |
| Indicat. ECONO | ECO driving indicator light | OFF or ON | - |
| Indicat. Lamp ECT PWR | Power mode indicator light | OFF or ON | - |
| Indicat. Lamp Cruise | Cruise main indicator light | OFF or ON | - |
| Indicat. Lamp Brake | Brake warning light | OFF or ON | - |
| Indicat. EPS | EPS warning light | OFF or ON | - |
| Master Warning | Master warning light | OFF or ON | - |
| Indicat. Ready (HV) | Ready indicator light | OFF or ON | - |
| Indicat. EV Mode | EV mode indicator light | OFF or ON | - |
| Indicat. ECO MODE | ECO mode indicator light | OFF or ON | - |
| Water Temperature Meter Operation | Engine coolant temperature receiver gauge | HIGH, 120, 110, NORMAL, 80, 70, 60, LOW | - |
| HV System Indicator | Hybrid System Indicator | MIN, -50, 0, 100, 200, 300, 400, MAX | - |
| Meter Display 1 | Multi-information display | All the dots in the multi-information display OFF or ON | - |
*1: for models with mph units
*2: for models with km/h units