POWER MANAGEMENT CONTROL ECU REMOVAL


  1. REMOVE REAR FLOOR MAT


    1. A003TLX

      Remove the rear floor mat.

  2. REMOVE REAR DECK FLOOR BOX


    1. A003TAA

      Remove the rear deck floor box.

  3. REMOVE BATTERY BOX COVER


    1. A003UZD

      Disengage the 3 guides and remove the battery box cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A003SPSE03

      Disengage the 3 claws.

    2. Disengage the guide and remove the No. 2 instrument panel under cover sub-assembly.

  6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    1. A003TTXE02
      Text in Illustration
      *1 Stopper
      *2 Glove Compartment Door Stopper

      Disengage the claw and release the glove compartment door stopper.

    2. Bend portions (A) and (B) in the direction indicated by the arrows in the illustration to release the 2 stoppers, and lower the glove compartment door assembly until the front of the door is level.

    3. A003TCOE03
      Text in Illustration
      *1 Hinge

      Pull the glove compartment door assembly horizontally toward the rear of the vehicle to release the 2 hinges, and remove the glove compartment door assembly.

      Note

      Pulling the glove compartment door assembly upward to remove it will cause the hinges to deform when reinstalling the door. Be sure to pull out the compartment door horizontally.

  7. REMOVE ECU INTEGRATION BOX (for LHD)


    1. A003TNM

      Disengage the 2 clamps.

    2. Remove the bolt and 2 nuts.

    3. Disconnect each connector and remove the ECU integration box.

  8. REMOVE POWER MANAGEMENT CONTROL ECU (for LHD)


    1. A003UGG

      Disengage the 2 claws and remove the power management control ECU.

  9. REMOVE ECU INTEGRATION BOX (for RHD)


    1. A003RTY

      Disconnect each connector.

    2. Disengage each clamp and disconnect the wire harness.

    3. Remove the bolt and screw.

    4. Disengage the claw and remove the ECU integration box.

  10. REMOVE POWER MANAGEMENT CONTROL ECU (for RHD)


    1. A003UPV

      Disengage the 2 claws and remove the power management control ECU.