REAR VIEW MONITOR SYSTEM (w/o Navigation System) Inner Rear View Mirror Power Source Circuit

DESCRIPTION

This circuit detects the state of the power switch, and sends it to the inner rear view mirror assembly.

WIRING DIAGRAM

A003TYLE01

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (BATTERY - INNER REAR VIEW MIRROR ASSEMBLY)


    1. Disconnect the O10 connector from the inner rear view mirror assembly.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      O10-1 (IG) - O10-2 (E) Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here