RELAY ON-VEHICLE INSPECTION


  1. INSPECT HEADLIGHT DIMMER RELAY (DIM / DRL)


    1. A01J9OIE04

      Remove the headlight dimmer relay from the engine room relay block.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the headlight dimmer relay.

  2. INSPECT REAR FOG LIGHT RELAY


    1. A01JCHPE86

      Remove the rear fog light relay.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the rear fog light relay.

  3. INSPECT RUNNING LIGHT RELAY (DRL)


    1. A01JCHPE86

      Remove the running light relay.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the running light relay.