STOP LIGHT CONTROL RELAY INSPECTION


  1. INSPECT STOP LIGHT CONTROL ECU ASSEMBLY


    1. A01J9W7E02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Stop Light Control ECU Assembly)

      Disconnect the A28 stop light control ECU assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A28-5 (STP) - Body ground Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V
      A28-6 (+B) - Body ground Always 11 to 14 V

      If the result is not as specified, repair or replace the wire harness or connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A28-8 (GND) - Body ground Always Below 1 Ω

      If the result is not as specified, repair or replace the wire harness or connector.

    4. A01J97AE02
      Text in Illustration
      *1

      Component without harness connected

      (Stop Light Control ECU Assembly)

      Reconnect the A28 stop light control ECU assembly connector.

    5. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A28-1 (OUT) - Body ground Brake pedal released Below 1 V
      Brake pedal depressed 11 to 14 V

      If the result is not as specified, the stop light control ECU assembly may have a malfunction.