STOP LIGHT SWITCH INSTALLATION


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A01JAGJ

      Insert the stop light switch assembly until the rod hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A01JAWB

      Make a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf, or less }

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the rod.

      Protrusion of the rod
      1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      If the protrusion is not as specified, adjust it.

      Note

      Do not depress the brake pedal.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


    1. Connect each connector.

    2. A01JB1P

      Engage the guide and claw.

    3. Install the No. 1 instrument panel under cover sub-assembly with the 2 screws <D>.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)


    1. Connect each connector.

    2. A01JA4G

      Engage the guide and 2 claws.

    3. Install the No. 1 instrument panel under cover sub-assembly with the screw <D>.