HIGH MOUNTED STOP LIGHT ASSEMBLY INSTALLATION

Note

When installing the center stop light set, perform the installation procedure from step 2.


  1. INSTALL CENTER STOP LIGHT ASSEMBLY


    1. Connect the center stop light assembly connector.

    2. A01J94GE01

      Install the center stop light assembly with the 2 screws.

  2. INSTALL CENTER STOP LIGHT SET


    1. Secure the wire running through the rear spoiler assembly to the center stop light set wire harness.

    2. A01JB0EE01
      Text in Illustration
      *1 Wire Harness
      *2 Gasket
      *3 Wire
      *4 protective tape
      *5 Cloth

      Place a cloth on the rear spoiler assembly as shown in the illustration.

    3. Using a clip remover wrapped with protective tape, widen the space inside the rear spoiler assembly, and pull the wire to pass the center stop light set wire harness through the spoiler.

      Note


      • Do not apply excess force to the rear spoiler assembly or it may be damaged.

      • Do not damage the gasket of the rear spoiler assembly.

      • Do not apply excess force when pulling the wire harness or it may break.

    4. A01J8T2E01
      Text in Illustration
      *1 Wire

      Install the center stop light set with the 2 screws to the rear spoiler assembly.

      Torque:
      1.2 N*m  { 12 kgf*cm, 11 in.*lbf }

    5. Remove the wire from the old center stop light set wire harness.

  3. INSTALL REAR SPOILER ASSEMBLY


    1. A01JCZ9

      Engage the 2 clips to install the rear spoiler assembly.

    2. A01J945

      Install the 5 nuts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    3. Connect the connector.

  4. INSTALL BACK DOOR TRIM BOARD


    1. A01JD91

      Engage the 5 clips and 2 guides to install the back door trim board.

  5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. A01J8I5

      Engage the 11 clips and 2 claws to install the back door panel trim assembly.

  6. INSTALL BACK DOOR SIDE GARNISH LH


    1. A01JD5B

      Engage the 3 clips and 2 claws to install the back door side garnish LH.

  7. INSTALL BACK DOOR SIDE GARNISH RH


    1. A01JBBG

      Engage the 3 clips and 2 claws to install the back door side garnish RH.

  8. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A01J9Q5

      Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.