LICENSE PLATE LIGHT ASSEMBLY INSTALLATION


  1. INSTALL LICENSE PLATE LIGHT BULB


    1. Install the license plate light bulb to the license plate light socket and wire.

    2. A01JCQC

      Turn the license plate light bulb and license plate light socket and wire in the direction indicated by the arrow shown in the illustration and install them as a unit.

  2. INSTALL LICENSE PLATE LIGHT ASSEMBLY


    1. A01JCZR

      Engage the 2 claws to install the license plate light assembly.

    2. Connect the connector.

  3. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. A01J918E01
      Text in Illustration
      *1 String
      *2 Double-sided Tape
      *3 Center line

      Wind double-sided tape around a string as shown in the illustration.

      Tech Tips

      The string is used to prevent the edge of the No. 2 back window lower moulding from being tucked under the back door outside garnish sub-assembly during installation.

      Standard Dimension
      a 1600.0 mm (62.992 in.)
      b 50.0 to 75.0 mm (1.969 to 2.953 in.)
      c 30.0 mm (1.181 in.)
    2. A01JD53E01
      Text in Illustration
      *1 String
      *2 Double-sided Tape
      *3 No. 2 back window lower moulding
      *4 Tape

      Lift the ends of the No. 2 back window molding lower, and attach each end to the back door glass with tape.

      Standard Dimension
      a 40.0 mm (1.575 in.)

    3. Make a loop in the center of the string, and attach it to the back of the No. 2 back window lower moulding with the double-sided tape on the string.

    4. Attach the loop and ends of the string to the back door glass with tape as shown in the illustration.

    5. Install the 4 new gaskets to the back door outside garnish sub-assembly.

    6. Install 11 new clips (back door outside garnish clip) to the back door outside garnish sub-assembly.

    7. A01JAGV

      Engage the 11 clips to install the back door outside garnish sub-assembly.

      Tech Tips

      Make sure that the string does not get pulled out from the back of the No. 2 back window molding lower.

    8. A01JBLE

      Install the 4 nuts.

    9. Apply soapy water to the No. 2 back window molding lower.

    10. A01J959E01

      Remove the string by slowly pulling out toward each end from the center toward the sides of the vehicle as shown in the illustration.

      Note

      Do not damage the No. 2 back window lower moulding.

    11. Check that the No. 2 back window molding lower is not pinched between the back door and the back door outside garnish sub-assembly.

    12. Remove the tape.

  4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. A01J8I5

      Engage the 11 clips and 2 claws to install the back door panel trim assembly.