HEADLIGHT LEVELING SWITCH INSPECTION


  1. INSPECT HEADLIGHT LEVELING SWITCH


    1. A01J90XE06
      Text in Illustration
      *1

      Component without harness connected

      (Headlight Leveling Switch)

      Connect a (+) lead from the battery to terminal 1 and a (-) lead to terminal 4.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Position

      Specified Condition

      (Battery voltage is 12 V)
      2 - 1 0 9.48 to 10.2 V
      (0.5) 8.77 to 9.49 V
      1 8.06 to 8.78 V
      (1.5) 7.36 to 8.08 V
      2 6.65 to 7.37 V
      (2.5) 5.94 to 6.66 V
      3 5.23 to 5.95 V
      (3.5) 4.52 to 5.24 V
      4 3.82 to 4.54 V
      (4.5) 3.1 to 3.83 V
      5 2.4 to 3.12 V

      If the result is not as specified, replace the switch.

    3. Connect a (+) lead from the battery to terminal 3 and a (-) lead to terminal 4.

    4. Check that the illumination of the switch comes on.

      OK
      The illumination comes on.

      If the result is not as specified, replace the switch.