HEADLIGHT ASSEMBLY REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  7. REMOVE HEADLIGHT ASSEMBLY


    1. A01JARUE01

      Remove the bolt and 2 screws.

    2. Using a screwdriver wrapped with protective tape, disengage the claw.

      Text in Illustration
      *1 Protective Tape
    3. A01J954

      Disengage the clamp.

    4. Disconnect each connector and remove the headlight assembly.